The PropStick USB is a rapid development tool for the powerful 8-cog multiprocessing Propeller microcontroller. The flexibility of a 40-in DIP package is combined with the convenience of an onboard Propeller P8X32A-M44, EEPROM, voltage regulator, removable 5 MHz crystal, reset button, and USB interface. This module is ready for rapid protoyping use in a breadboard, perfboard with wire-wrap, or in a 600 mil 40-pin socket soldered to a PCB.

The PropStick USB is intended to be used in a breadboard or other through-hole design.  The PropStick USB is included with the breadboard-based Propeller Education Kit - PropStick USB Version.

Features:

Propeller P8X32A-M44 chip
32kB 24LC256-I/ST EEPROM
FTDI FT232RG and mini USB connector
USB data transfer indicator LEDs
5 MHz crystal in a removable socket
3.3V 500mA voltage regulator
Reset pushbutton switch
 

Key Specifications:

Power requirements: regulated 6 - 9 VDC. 
Communication: 232R USB interface to PC for programming and bidirectional communication
Dimensions: 2.0 x 0.6 x 0.45 in (51 x 16 x 12 mm)
Operating temp range: +32 to +158 °F (0 to +70 °C)

ROHS Compliant

Note: The PropStick USB is not intended to be plugged into 40-pin sockets made for the Parallax. BASIC Stamp 2p40, due to differences in programming interface, pinouts, and supply voltages.

Downloads & Resources:

PropSTICK USB Documentation (.pdf)

Propeller Articles, Software, and Documentation
Propeller Object Exchange (Off Site)
Propeller Q & A

Open-Source Hardware Designs:
Schematic (.sch)
Layout (.dip)
Bill of Materials (.ods)