Get started with the fabulous Adafruit Flora platform with this lovely starter kit. Included are plenty of parts to make a few different fun projects! There's a Flora motherboard, a GPS module that can also perform location datalogging, eight ultra-bright chainable RGB pixels, a battery holder and batteries, two types of our high quality stainless steel thread, alligator clips to help you test out your parts, a USB cable for reprogramming the Flora, and some parts to make a wearable remote control (or TV-B-Gone!): NPN transistors, long range IR LEDs, and matching resistors. 

• FLORA main board 
• Flora Wearable Ultimate GPS module
• Eight Flora RGB NeoPixels V2
• 3xAAA Battery holder with JST connector and on/off switch
• Stainless Thin Conductive Thread - 2 ply - 25 meter/85 ft
• Stainless Medium Conductive Thread - 3 ply - 18 meter/60 ft
• Needle set with 20 pieces
• Small Alligator Clip Test Lead (set of 12)
• USB cable - A/MicroB - 3ft
• 4x Alkaline AAA batteries
• 2x NPN Bipolar Transistors (PN2222)
• 2x Super-bright 5mm IR LEDs
• 2x 100-ohm resistors

We guarantee lots of safe sewing fun!

You may get a FLORA with an off-white or black JST connector.