Out of the box, the bladeRF can tune from 300MHz to 3.8GHz without the need for extra boards. Through open source software such as GNURadio (live image), the bladeRF can be placed into immediate use. With its flexible hardware and software, the bladeRF can be configured to operate as a custom RF modem, a GSM and LTE picocell, a GPS receiver, an ATSC transmitter, or a combination Bluetooth/WiFi client, without the need for any expansion cards. All of the bladeRF host software, firmware, and HDL is open source, and available on GitHub.

Highlights:

  • Full-duplex 40MSPS 12bit quadrature sampling
  • Factory calibrated VCTCXO tuned within 1 Hz of 38.4 MHz
  • Removable-cap RF shields for increased system sensitivity and isolation
  • Flexible clocking architecture for arbitrary sample rates
  • GPIO expansion port ( GPIO Expansion Board )
  • SPI flash allows for headless operation
  • Expanded frequency coverage using XB-200 Transverter Board
  • Typical +6dBm TX power

Technical Specifications:

  • Fully bus-powered USB 3.0 SuperSpeed Software Defined Radio
  • Portable, handheld form factor: 5" by 3.5"
  • Gold plated RF SMA connectors
  • 300MHz - 3.8GHz RF frequency range
  • Independent RX/TX 12-bit 40MSPS quadrature sampling
  • Flexible clocking architecture
  • Capable of achieving full-duplex 28MHz channels
  • 16-bit DAC factory calibrated 38.4MHz +/-1ppm VCTCXO
  • On-board 200MHz ARM9 with 512KB embedded SRAM (JTAG port available)
  • On-board 40KLE Altera Cyclone 4 E FPGA (JTAG port available)
  • 2x2 MIMO configurable with SMB cable, expandable up to 4x4
  • Modular expansion board design for adding GPIO and expanding frequency range,
  • DC power jack for running headless
  • Highly efficient, low noise power architecture
  • Stable Linux, Windows, Mac and GNURadio software support

 

USB 3.0 Superspeed

High speed, low latency and increased power delivery over a single cable: USB 3.0 Superspeed is the perfect interface for a wide bandwidth radio front end to modern computers. The Cypress FX3 microcontroller is the ideal solution with a powerful ARM9 processor and enough bandwidth to saturate the full duplex 5Gbps USB 3.0 link.
Fully Programmable FPGA

An Altera Cyclone IV FPGA provides the interface between the FX3 and RF transceiver. This FPGA has single-cycle access embedded memory, hard 18x18 multipliers for dedicated DSP and many general logic elements ready to be programmed.
Wideband RF Transceiver

From bits to RF, the LimeMicro LMS6002D is a fully integrated RF transceiver. Made to power picocell stations, this transceiver is capable of handling anything from simple FM audio to the latest 4G LTE standard to whatever the future may hold.




Professional Quality

The bladeRF's design has been tested and verify to meet our very high standards. At peak RF performance, the bladeRF can occupy 28MHz of bandwidth over its operating bandwidth without any significant spurs.

Documents:

Package Includes:

  • bladeRF x40  (40KLE Cyclone 4 FPGA)
  • USB 3.0 SS cable
  • 2x SMA cables
 

 

SDR Specifications
Tuning range 300MHz to 3.8GHz
Duplex Full-duplex
Max sampling rate 40MSPS
ADC/DAC resolution 12bit quadrature sampling
Max RF bandwidth 28MHz

Write a review

Please login or register to review

bladeRF X40

  • Brand: Nuand
  • Product Code:Nuand-bladeRF-x40
  • Reward Points:660
  • Availability:In Stock
  • रo 66,033.00

  • Ex Tax:रo 66,033.00
  • Price in reward points:66033

  • 2 or more रo 65,496.00

Related Products

Ham It Up v1.3 Barebones - HF Upconverter

Ham It Up v1.3 Barebones - HF Upconverter

Now shipping v1.3!  We believe this is the best SDR upconverter available. Here is why.Major ve..

रo 5,685.00 Ex Tax:रo 5,685.00

HackRF One, an open source SDR platform

HackRF One, an open source SDR platform

HackRF One from Great Scott Gadgets is a Software Defined Radio peripheral capable of transmission o..

रo 26,850.00 रo 27,721.00 Ex Tax:रo 26,850.00

RF Connect Wireless Radio Boards AXE213

RF Connect Wireless Radio Boards AXE213

The AXE213 is a pair of boards which allow simple PICAXE to PICAXE (or PICAXE to PC) interfacing usi..

रo 1,385.00 Ex Tax:रo 1,385.00

bladeRF x115

bladeRF x115

Kit includes:   bladeRF x115 (115KLE Cyclone 4 FPGA) USB 3.0 SS cable 2x SMA..

रo 98,244.00 Ex Tax:रo 98,244.00

bladeRF x115 Thermal (-40C to 85C)

bladeRF x115 Thermal (-40C to 85C)

Kit includes:   bladeRF x115  (115KLE Cyclone 4 FPGA) USB 3.0 SS cable 2x SM..

रo 232,966.00 Ex Tax:रo 232,966.00

GPIO expansion board

GPIO expansion board

The XB-100 expansion board turns the bladeRF into an FPGA development board by providing access to a..

रo 7,054.00 Ex Tax:रo 7,054.00

Transverter LF/MF/HF/VHF

Transverter LF/MF/HF/VHF

The XB-200 is a block up-down converter that greatly expands the bladeRF’s lower frequency range. Th..

रo 31,747.00 Ex Tax:रo 31,747.00

Amplifier bladeRF - XB-300

Amplifier bladeRF - XB-300

The XB-300 is an amplifier expansion card that greatly expands the bladeRF’s RF performance. The amp..

रo 19,075.00 Ex Tax:रo 19,075.00

bladeRF case

bladeRF case

Description: The case fits bladeRFs with Type A and Type B connectors. The bladeRF case feat..

रo 2,581.00 Ex Tax:रo 2,581.00

Power Supply for bladeRF

Power Supply for bladeRF

DC power supply, compatible with all bladeRF 1.0 and 2.0 devices. Kit includes: 1x US/EU..

रo 2,103.00 Ex Tax:रo 2,103.00

BladeRF Expansion Board Case

BladeRF Expansion Board Case

The case fits bladeRFs with Type A and Type B connectors. The case perfectly fits the XB-200 and XB-..

रo 2,839.00 Ex Tax:रo 2,839.00

Antenna - Software Defined Radio

Antenna - Software Defined Radio

ChipDesign's tunable antenna for mobile devices consists of a low-profile electronically-tunable ele..

रo 4,199.00 Ex Tax:रo 4,199.00

KiwiSDR

KiwiSDR

KiwiSDR is a software-defined radio (SDR) covering shortwave, the longwave & AM broadcast bands, var..

रo 22,994.00 Ex Tax:रo 22,994.00

Adafruit 945/944 2.4GHz Dipole Swivel Antenna with RP-SMA - 2dBi / 5dBi

Adafruit 945/944 2.4GHz Dipole Swivel Antenna with RP-SMA - 2dBi / 5dBi

This is 4"/100mm long swivel dipole antenna for 2dBi of gain and 50Ω impedance and 8"/200mm long swi..

रo 966.00 Ex Tax:रo 966.00

Antenna 700~5800 MHz

Antenna 700~5800 MHz

Designed to cover all cellular, ISM and Wi-Fi working frequencies. 698-960 MHz, 1575.42 MHz, 1710-27..

रo 6,210.00 Ex Tax:रo 6,210.00

SDR 1 MHz to 6 GHz - HackRf One

SDR 1 MHz to 6 GHz - HackRf One

SDR-1 MHz to 6 GHz   1 MHz to 6 GHz operating frequency half-duplex transceiver ..

रo 21,785.00 Ex Tax:रo 21,785.00

Hak5 Elite Field Kit

Hak5 Elite Field Kit

This exclusive Field Kit combines the most popular Hak5 signature gear, all compiled in our Elite Eq..

रo 87,125.00 Ex Tax:रo 87,125.00

LimeSDR Mini

LimeSDR Mini

The LimeSDR Mini development board is a hardware platform for developing and prototyping high-perfor..

रo 19,985.00 Ex Tax:रo 19,985.00

Ultra-WideBand Vivaldi Antenna 800MHz to 6GHz+

Ultra-WideBand Vivaldi Antenna 800MHz to 6GHz+

This is an Ultra-wideband Vivaldi antenna. This antenna provides good gain from about 1.7GHz through..

रo 2,585.00 Ex Tax:रo 2,585.00

PandwaRF with various options

PandwaRF with various options

PandwaRF is a pocket-sized, portable RF analysis tool operating the sub-1 GHz range. It allows t..

रo 16,861.00 Ex Tax:रo 16,861.00

bladeRF 2.0 micro xA4

bladeRF 2.0 micro xA4

bladeRF 2.0 micro xA4, 47MHz to 6GHz frequency range, 61.44MHz sampling rate, 2×2 MIMO channels USB ..

रo 68,015.00 Ex Tax:रo 68,015.00

bladeRF 2.0 micro xA9

bladeRF 2.0 micro xA9

bladeRF 2.0 micro xA9, 47MHz to 6GHz frequency range, 61.44MHz sampling rate, 2×2 MIMO channels USB ..

रo 108,321.00 Ex Tax:रo 108,321.00

LimeNET Micro

LimeNET Micro

LimeNET Micro makes deploying wireless networks more accessible than ever before, by extending the L..

रo 34,090.00 रo 35,575.00 Ex Tax:रo 34,090.00

Tags: Bladerf x40 USB 3.0 GNU Radio 300MHz to 3.8GHz GPIO 1 Hz of 38.4 MHzRF 40MSPS 12bit quadrature sampling Windows Linux Mac

The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.

Name
Email
Phone
Comments