HackRF shown for installation demonstrational purposes only. HackRF is sold separately.
This kit requires basic soldering skills. Though these components are 'easy' to solder we don't recommend learning on your brand new HackRF!
The plastic enclosure included with HackRF slightly impedes the RF shield footprint area. This can be rectified either by purchasing our custom HackRF aluminum enclosure, or through minor modification of the plastic case, which can be done with a sharp hobby knife and a few minutes of time.
This kit contains the unpopulated RF shield for HackRF to help reduce stray EMI. The shield frame needs to be soldered to the board, and the shield cover mounts atop the frame.
Also included is the GND clip testpoint, J10, and a 20 position female header for P30 (BANK2_AUX).
Related Products
HackRF One 1MHz-6GHz SDR Development Board Open Source SDR Platform V1.9.1 Radio Receiver for World Map GPS Simulator
1 MHz to 6 GHz Frequency Range: The wide frequency range allows for versatile testing and developmen..
रo 17,552.00
SDR 1 MHz to 6 GHz - HackRf One
SDR-1 MHz to 6 GHz 1 MHz to 6 GHz operating frequency half-duplex transceiver ..
रo 21,785.00
Opera Cake for HackRF
Opera Cake is an antenna switching add-on board for HackRF One that is configured with command-line ..
रo 16,941.05
ESP32-MDK for Portapack H4M
The ESP32-MDK is an addon to the Portapack H4M to enable WiFi applications.Requires and not included..
रo 7,420.00
Tags: HackRF One, RF Shield