Super 10000µf ELNA Audio Capacitors   One CAP One Rail Design Eliminating Phase Distortion

One Super 10000µf ELNA Capacitor is used for each rail to eliminate potential phase distortion which could result from multiple caps in a single rail design.

Heavy Duty Aluminum Chassis with Fin-in-Fin Side Panel

Maximum Heat Dissipation Area and Fanless Operation-100% Silent

19V/12V/Adjustable Rail Independent Output:

True Separate Rail Design. No shared Ground. Guarantee No Cross RFI/EMI Interference. This is a must for multi-rail Linear Power Supply. All output can work at the same time with no loss of performance and no cross-talk with each other.

Linear Technology LT3045:

The LT3045 family is a high performance low dropout linear regulator featuring LTC’s ultralow noise and ultrahigh PSRR architecture for powering noise sensitive applications from Linear Technology. HDPLEX use four LT30451 in parallel for each adjustable rail to achieve 2A and further reduce ripple noise below 1mv. Eight LT30451 chips are used for two identical and independent adjustable rail.

Reliable and Versatile:

HDPLEX 300W Linear Power Supply uses high quality NEUTRIK XLR connector. XLR-7.4/5.0mm cable is included for HDPLEX 400W Hi-Fi DC-ATX Converter/Thin ITX AIO/Intel NUC system, XLR-5.5X2.5mm cable for PicoPSU, and XLR-5.5X2.1mm for PPA/SoTM/JPLAY USB Card and 5.5/2.5-SATA for SSD.

Features:

•  Twelve Linear Technology LT3045 chips for two adjustable rails to achieve extremely low noise.
•  Hi-End Audio ELNA Super 10000µf Capacitor, One for Each Rail, Eliminating Phase Distortion
•  High Quality 300W Silent R-Core Transformer provides clean energy
•  High Precision Over-Current Protection and Over Temperature Protection Achieved by LM2904+MCU Control
•  Separated Ground for Each Output Rail
•  EMI/RFI Circuit to Prevent AC Grid Pollution
•  No Humming or Buzz noise for 50Hz and Peak load, 100% Silent
•  High Quality Neutrik XLR Connector for All Outputs
•  Low ripple noise and void of high frequency noise
•  19V/10A XLR Output Supprt Thin ITX/NUC/Auralic Aries Mini/HDPLEX 4000W DC-ATX Converter
•  12V/10A XLR Output Support Legacy Wavelet DAC/Qnap Nas/PicoPSU or 12V based CE device.
•  Two independent adjustable output is 3.3V/5V/7.5V/9V/12V/15V and 3AMP MAX. Each rail uses six LT3045 chips. It supports SoTM PCIE USB card/MicroRendu/Upton USB Regen/ PPA (Paul Professional Audio) USB Audio card and Squeezebox.
•  Passive aluminum chassis guarantee absolute silent and stable operation
• Chassis Material/Color: Brushed Aluminum/ All Black
• Power ON/OFF Switch: Yes (On the Back Plate )
• Operating Temperature: -10C - 70C
• Safety: Overvoltage Protection(OVP), Undervoltage Protection(UVP), Overcurrent Protection(OCP), Short Circuit Protection
• Certification:
• CE/EN60950-1 (TCT1405072566S-1)
• RoHS (TCT1405074557R-1)
• FCC (TCT1405074391F-1)
• EMC (TCT1405073270E-1)
• Idle Power Consumption: < 4W
• Size:320(L) x 215 (W) x 85 (H) mm
• Weight:10kg/22 lbs
• Input Voltage: 110V/240V AC (MAX 260V AC)
• AC Input Connector: IEC with EMI Filter
• DC Output:19V/12V XLR---7.4x5.0mm/5.5x2.5mm/5.5x2.1mm Connector
• DC Output:Two Adjustable XLR---5.5x2.5mm/5.5x2.1mm(For PPA/SOTM Card) Connector.

HDPLEX High Precision Protection Circuit Explained:

• HDPLEX 300W Linear Power Supply high precision protection circuit contains TI LM2904 OP AMP and MCU Control Chip with customized program.
• Over Current Protection Cut-Off Point is 13A for 19V and 12V High Current Rail.
• Over Current Protection Cut-Off Point is 3.3A for Two Adjustable Rail.
• Over Temperature Protection Cut-Off Point is set at 80°C Degree.
• Each Rail is protected separately and will recover in 10s after AC power cord is disconnected.
• The OVP/UVP/OCP circuit is to prevent external device from damaging HDPLEX 300W Linear PSU by drawing too much power such as short circuit.
• They also protect your external device from being damaged by HDPLEX 300W Linear PSU.
• HDPLEX 300W Linear PSU Diagram:

Package Includes:

• 1 x HDPLEX 300W Linear Power Supply
• 1 x XLR---7.4*5.0 w/PIN Cable(3ft/1m)

• 2 x XLR---5.5/2.5mm Connector Cable(5ft/1.5m) and 2 x XLR---5.5/2.1mm Connector Cable(5ft/1m) (For PicoPSU/SoTM/PPA/JPLAY USB Card External 9V Input,Squeezebox 5V Input)